Skil 4680 User Manual download pdf (Page 7)

Attaching the Blade

To prevent personal injury,

always disconnect plug from

power source before assembling parts, making

adjustments, or changing blades.

1. Insert the saw blade (teeth in cutting

direction) until it latches in the plunger

(Fig. 2).

When inserting the saw blade, the back of

the blade must rest in the groove of the

guide roller (Fig. 3).

2. To remove blade, lift tool-less blade change

cover up with index finger and thumb and

remove blade.

For use with both T or U shank jigsaw blades.

-

7-

Assembly

VARIABLE SPEED CONTROLLED

TRIGGER SWITCH

Your tool is equipped with a variable speed

trigger switch. The tool can be turned "ON" or

"OFF" by squeezing or releasing the trigger. The

speed can be adjusted from the minimum to

maximum nameplate SPM by the pressure you

apply to the trigger. Apply more pressure to

increase the speed and release pressure to

decrease speed (Fig. 1).

"LOCK-ON" BUTTON

The "Lock-ON" button, located in the handle

of your tool allows for continuous operation at

maximum SPM without holding the trigger

(Fig. 1).

TO LOCK TRIGGER "ON": squeeze trigger,

depress button and release trigger.

TO UNLOCK THE TRIGGER: squeeze trigger

and release it without depressing the "Lock-

ON" button.

If the “Lock-ON” button is

continuously being depressed,

the trigger can not be released.

PLUNGER SPEED

The stroke rate may be adjusted as described

earlier under “Variable Speed Controlled

Trigger Switch”. The best results for a

particular application is determined by

experience, though as a general rule, slower

speeds are for denser materials and faster

speeds are for soft materials.

LASER LIGHT/SITE-LIGHT™

CONTROL WHEEL

LASER RADIATION. AVOID

DIRECT EYE EXPOSURE.

DO NOT stare into the laser light source.

Never aim light at another person or object

other than the workpiece.

Laser light can

damage your eyes.

DO NOT use tinted glasses

to enhance the laser light.

Tinted glasses will reduce overall vision for

the application and interfere with the normal

operation of the tool.

Never aim the beam at a

workpiece with a reflective

surface.

Bright shiny reflective sheet steel or

similar reflective surfaces are not

recommended for laser use. Reflective

surfaces could direct the beam back toward

the operator.

The 4 position control wheel allows you to

control the function of the lights. Below, lists

the function of each setting (Fig. 1).

Setting 1: Turns OFF all lights.

Setting 2: Turns ON only the Laser light.

Setting 3:

Turns ON both the Laser light and

the Site-Light.

Setting 4: Turns ON only the Site-Light.

!

WARNING

!

WARNING

Operating Instructions

FIG. 2

FIG. 3

TOOL-LESS

BLADE CHANGE

COVER

ROLLER GUIDE

BLADE

DANGER

!

!

WARNING

!

WARNING

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Comments to this Manuals

No comments