Skil 2354-02 Use and Care Manual download pdf (Page 5)

Do not run the tool while carrying it at your

side. A spinning bit could become entangled

with clothing and injury may result.

Do not use dull or damaged bits and

accessories. Dull or damaged bits have a

greater tendency to bind in the workpiece.

Some dust created by

power sanding, sawing,

grinding, drilling, and other construction

activities contains chemicals known to

cause cancer, birth defects or other

reproductive harm. Some examples of

these chemicals are:

• Lead from lead-based paints,

• Crystalline silica from bricks and cement

and other masonry products, and

• Arsenic and chromium from chemically-

treated lumber.

Your risk from these exposures varies,

depending on how often you do this type of

work. To reduce your exposure to these

chemicals: work in a well ventilated area, and

work with approved safety equipment, such

as those dust masks that are specially

designed to filter out microscopic particles.

Battery/Charger

Before using battery charger, read all

instructions and cautionary markings on (1)

battery charger, (2) battery pack, and (3)

product using battery.

Hold power tools by insulated gripping surfaces

when performing an operation where the

cutting tools may contact hidden wiring.

Contact with a “live” wire will make exposed metal

parts of the tool “live” and shock the operator.

Use clamps or other practical way to secure

and support the workpiece to a stable

platform. Holding the work by hand or

against your body leaves it unstable and may

lead to loss of control.

Do not drill, fasten or break into existing

walls or other blind areas where electrical

wiring may exist. If this situation is

unavoidable, disconnect all fuses or circuit

breakers feeding this worksite.

Battery tools are always in an operative

condition. Be aware of the possible hazards.

Always wear safety goggles or eye

protection when using this tool.

Secure the workpiece, never hold it in your

hand or across legs. The drilling action may

cause you to lose control of the

workpiece and injury may occur.

When installing a bit, insert the shank of the bit

well within the collet. If the bit is not inserted

deep enough, the grip of the collet over the bit is

reduced and the loss of control is increased.

SAFETY RULES FOR CORDLESS

SCREWDRIVERS

WARNING

SM 1619X05087 12-09:SM 1619X05087 12-09 1/4/10 9:18 AM Page 8

1 2 3 4 5 6 7 8 9 10 ... 40 41

Comments to this Manuals

No comments

Skil 2354-02 Use and Care Manual Page 5

Comments to this Manuals

Related products and manuals for Power tools Skil 2354-02