Skil 2354-02 Use and Care Manual download pdf (Page 6)

Battery Care

When batteries are not in

tool or charger, keep them

away from metal objects. For example, to

protect terminals from shorting DO NOT place

batteries in a tool box or pocket with nails,

screws, keys, etc. Fire or injury may result.

DO NOT PUT BATTERIES INTO FIRE OR

EXPOSE TO HIGH HEAT. They may explode.

Battery Disposal

Do not attempt to

disassemble the battery or

remove any com ponent projecting from the

battery terminals. Fire or injury may result.

Prior to disposal, protect exposed terminals

with heavy insulating tape to prevent shorting.

Lithium-ion Batteries

If equipped with a lithium-ion battery, the battery

must be collected, recycled or disposed of in an

environ mentally sound manner.

“The EPA certified RBRC

Battery Recycling Seal on the

lithium-ion (Li-ion) battery

indicates Robert Bosch Tool

Corporation is voluntarily

participating in an industry program to collect

and recycle these batteries at the end of their

useful life, when taken out of service in the

United States or Canada. The RBRC program

Do not disassemble charger or operate the

charger if it has received a sharp blow, been

dropped or otherwise damaged in any way.

Replace damaged cord or plugs

immediately. Incorrect reassembly or

damage may result in electric shock or fire.

Do not recharge battery in damp or wet

environment. Do not expose charger to rain

or snow. If battery case is cracked or

otherwise damaged, do not insert into

charger. Battery short or fire may result.

Charge battery pack in temperatures above

+32 degrees F (0 degrees C) and below +113

degrees F (45 degrees C). Store tool and

battery pack in locations where

temperatures will not exceed 120 degrees F

(49 degrees C). This is important to

prevent serious damage to the battery cells.

Place charger on flat non-flammable

surfaces and away from flammable

materials when re-charging battery pack.

The charger and battery pack heat during

charging. Carpeting and other heat insulating

surfaces block proper air circulation which

may cause overheating of the charger and

battery pack. If smoke or melting of the case

are observed unplug the charger immediately

and do not use the battery pack or charger.

Use of an attachment not recommended or

sold by Skil may result in a risk of fire,

electric shock or injury to persons.

10

11

!

WARNING

!

WARNING

SM 1619X05087 12-09:SM 1619X05087 12-09 1/4/10 9:18 AM Page 10

1 2 3 4 5 6 7 8 9 10 11 ... 40 41

Comments to this Manuals

No comments