Skil 2354-02 Use and Care Manual download pdf (Page 10)

When the indicator light turns “OFF” fast

charging is complete.

If the green charging indicator light turns red

during use, this indicates the battery needs to

be charged.

After normal usage, the battery requires

approximately 3 to 5 hours charging time to

reach full capacity. The tool may be used even

though the light may still be on. The light may

require more than 3 hours to turn off depending

on temperature.

The purpose of the light is to indicate that the

battery is fast-charging. It does not indicate the

exact point of full charge. The light will turn off

in less than 3 hours if the battery was not

completely discharged.

When the battery is fully charged, unplug the

charger (unless you're charging another tool).

INSERTING BITS

Your tool is equipped with an magnetic bit

holder. Simply push the bit into the bit holder as

far as it will go (Fig. 3).

FASTENING WITH SCREWS

The procedure shown in figure. 4 will enable

you to fasten materials together with your

Cordless Screwdriver without stripping,

splitting, or separating the material.

First, clamp the pieces together and drill the first

hole 2/3 the diameter of the screw. If the

green indicator light depicting a forward arrow

will light up.

For reverse rotation move the lever to the far

right and the green indicator light depicting a

reverse arrow will light up.

To stop in either direction just release the

trigger. To activate trigger lock move lever to

the center off position (Fig. 1).

AUTOLOCK™

Your tool is equipped with an automatic locking

system. This feature will lock the bit holder in

one position when the trigger switch is

released. This will allow you to tighten or loosen

a nut or screw by rotating the tool by hand with

the switch off. This is convenient when higher

turning torque is needed.

SITE-LIGHT™

Your tool is also equipped with a light that turns

on automatically when the switch is

activated for better visibility during operation

(Fig. 1). The Site-Light™ is maintenance free

and was designed to last the life of your tool.

CHARGING THE TOOL

For Model # F012235400: Plug charger into

your standard power outlet, then insert charger

plug into tool (Fig. 2).

The green charging indicator light on the tool

will turn “ON”. This indicates that the battery is

receiving a fast charge. Fast-charging will

automatically stop when the battery is fully

charged.

SM 1619X05087 12-09:SM 1619X05087 12-09 1/4/10 9:18 AM Page 18

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 40 41

Comments to this Manuals

No comments

Skil 2354-02 Use and Care Manual Page 10

Comments to this Manuals

Related products and manuals for Power tools Skil 2354-02