Skil 5585-01 Use and Care Manual download pdf (Page 5)

-5-

Additional Safety Warnings

and does not touch the blade or any other part,

in all angles and depths of cut.

Check the operation of the lower guard

spring. If the guard and the spring are not

operating properly, they must be serviced

before use. Lower guard may operate

sluggishly due to damaged parts, gummy

deposits, or a buildup of debris.

Lower guard should be retracted manually

only for special cuts such as “Plunge Cuts”

and “Compound Cuts”. Raise lower guard

by lower guard lift lever and as soon as

blade enters the material, lower guard must

be released. For all other sawing, the lower

guard should operate automatically.

Always observe that the lower guard is

covering the blade before placing saw

down on bench or floor. An unprotected,

coasting blade will cause the saw to walk

backwards, cutting whatever is in its path. Be

aware of the time it takes for the blade to stop

after switch is released.

Do not run the tool while carrying it at your

side. Lower guard may be opened by a

contact with your clothing. Accidental

contact with the spinning saw blade could

result in serious personal injury.

Periodically remove the blade, clean the

upper, lower guards and the hub area with

kerosene and wipe it dry, or blow it clean

with compressed air. Preventive maintenance

and properly operating guard will reduce the

probability of an accident.

GFCI and personal protection devices like

electrician’s rubber gloves and footwear will

further enhance your personal safety.

Do not use AC only rated tools with a DC

power supply. While the tool may appear to

work, the electrical components of the AC

rated tool are likely to fail and create a hazard

to the operator.

Keep handles dry, clean and free from oil

and grease. Slippery hands cannot safely

control the power tool.

Use clamps or another practical way to

secure and support the workpiece to a

stable platform. Holding the work by hand or

against your body leaves it unstable and may

lead to loss of control.

Develop a periodic maintenance schedule

for your tool. When cleaning a tool be

careful not to disassemble any portion of

the tool since internal wires may be

misplaced or pinched or safety guard return

springs may be improperly mounted.

Certain cleaning agents such as gasoline,

carbon tetrachloride, ammonia, etc. may

damage plastic parts.

Risk of injury to user. The power cord must only

be serviced by a Skil Factory Service Center or

Autho rized Skil Service Station.

Some dust created by power

sanding, sawing, grinding,

drilling, and other construction activities

contains chemicals known to cause cancer,

birth defects or other reproductive harm.

Some examples of these chemicals are:

• Lead from lead-based paints,

• Crystalline silica from bricks and cement and

other masonry products, and

• Arsenic and chromium from chemically-

treated lumber.

Your risk from these exposures varies,

depending on how often you do this type of

work. To reduce your exposure to these

chemicals: work in a well ventilated area, and

work with approved safety equipment, such as

those dust masks that are specially designed

to filter out microscopic particles.

!

WARNING

SM 1619X05345 03-10:SM 1619X05345 03-10 3/10/10 3:07 PM Page 5

1 2 3 4 5 6 7 8 9 10 ... 43 44

Comments to this Manuals

No comments