Skil 9296-01 Use and Care Manual download pdf (Page 10)

$" !!

Use wheel guard with disc

grinding wheels. Always

close the latch to secure the guard. Keep the

guard between you and the wheel. Do not

direct guard opening toward your body.

To attach wheel guard DISCONNECT tool

from power source.

Open guard release/lock latch and position

guard on spindle neck so that the three tabs on

guard, line up with the three notches on the

spindle neck (Fig. 2).

2. Tilt the guard forward so that you can insert

tab C into the notch on the spindle neck.

3. Push the guard down to insert tabs A & B

into the notch openings.

4. Rotate guard to desired location and close

guard release/lock latch to secure guard.

6;, If lock latch does not securely clamp the

guard to the spindle neck, open latch and

tighten adjustment screw to increase clamping

tension.

1. To remove guard, open guard release/lock

latch line up the three tabs on the guard with

the three notch openings on the spindle neck.

2. With an angled motion, lift the bottom

section of the guard out first releasing tabs A &

B form the notches in the gear spindle neck.

3. Then push the guard forward to release pin

C and remove guard.

::,4)3@

-10-

"!

Your tool is equipped with a threaded spindle

for mounting ac ces sories. Always use the

supplied lock nut (and backing flange) that

has same thread size as spindle.



The side handle used to guide and balance the

tool can be thread ed into the front housing on

either side of the tool, depending on per sonal

preference and comfort. Use the side handle

for safe control and ease of operation.

!

WARNING

0:*905+05.$/,,3::,4)3@

Disconnect tool from power source. Be sure

that wheel guard is in place for grinding.

Place BACKING FLANGE and GRINDING

WHEEL on the spindle. Thread on the lock

nut and tighten nut using the supplied lock

nut wrench, while holding the spindle lock in

(Fig. 3 & 3a).

TO REMOVE: Reverse procedure.

GRINDING

WHEEL

LOCK NUT

SPINDLE

WHEEL

GUARD

BACKING

FLANGE

LOCK NUT

GRINDING

WHEEL

BACKING

FLANGE

SPINDLE

FIG. 3

C

B

A

WHEEL

GUARD

ADJUSTMENT

SCREW

GUARD

RELEASE / LOCK

LATCH

SPINDLE

NECK

FIG. 2

SPINDLE

LOCK

FIG. 3a

SM 2610025798 10-12_SM 2610025798 10-12.qxp 10/12/12 9:32 AM Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Comments to this Manuals

No comments