Skil 9296-01 Use and Care Manual download pdf (Page 11)

 $!$!

!"

The Paddle switch enables the operator to

control the switch functions of "Lock-OFF",

and "ON/OFF".

TO UNLOCK SWITCH AND TURN TOOL

"ON": Push "Lock-OFF" switch release lever

backward to unlock paddle switch, then

squeeze paddle switch (Fig. 5).

TO SWITCH TOOL "OFF": Release pressure

on paddle lever. The switch is spring loaded

and will return to "OFF" position automatically

(Fig. 5).

(5+05.**,::690,:::,4)3@



Before attaching a backing

pad be sure its maximum

safe operating speed is not exceeded by the

nameplate speed of the tool.

Wheel guard may not be

used for most sanding

operations. Always reinstall wheel guard

when converting back to grinding operations.

! !

 

Disconnect tool from power source. Set the

tool on its top side (spindle up). Place the

rubber backing pad onto the spindle shaft.

Center the sanding disc on top of the backing

pad. Insert the lock nut through the disc and

thread onto the spindle as far as you can with

your fingers. Press in the spindle lock, then

tighten the backing pad securely with lock nut

wrench (Fig. 4).

!#

 

Disconnect tool from power source. Using

the lock nut wrench unscrew the nut from the

spindle, while holding spindle lock in.

$"  &

Before assembling wire brush to this tool,

disconnect from the power source. Wire

brushes are equipped with their own

threaded hub, simply thread on to spindle.

Be sure to seat against shoulder before

turning tool “ON”.

TO REMOVE: Reverse procedure.

Always use type 27 guard

system with wire wheels and

assure that wires fit within guard.

$$ &

Before assembling wire wheel to this tool,

disconnect from the power source. Attach type

27 guard (Fig. 2). Wire wheels are equipped

with their own threaded hub, simply thread on

to spindle. Be sure to seat against shoulder

before turning tool “ON”.

!

WARNING

!

WARNING

7,9(;05.5:;9<*;065:

-11-

SANDING

DISC

BACKING

PAD

LOCK NUT

WIRE BRUSH

SPINDLE

FIG. 4

FIG. 5

!

WARNING

PADDLE SWITCH

"LOCK-OFF" SWITCH

RELEASE LEVER

SM 2610025798 10-12_SM 2610025798 10-12.qxp 10/12/12 9:32 AM Page 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Comments to this Manuals

No comments